Skip to content

Your choice is stored for a year. You can change it at any time — the "Cookie settings" link is at the bottom of every page.

Learn more in the cookie policy.

RUICHI — home
Catalog
Contact us
NE555-5 — photo 1

NE555-5

Single-channel relay / time delay module RUICHI NE555-5V with timer from 1 to 10 seconds

Product overview
Item code126577
ModelNE555-5

Specifications

ParameterValueSelect
CategoryElectronic Modules › Miscellaneous
Height, mm18 mm
Depth, mm65 mm
ProtectionDC protection
Number of contacts3 / 2
Switching voltage, Vup to 220
Maximum load power, W2000 W
Maximum current, A10 A
Supply voltage, V5
Featureswith delay adjustment
Control modedelay time - 0...10 s
Module typeRelay module with switch-on delay
ChipNE555
Width, mm20 mm
Select parameters to find similar products

Description

Single-channel relay / time delay module RUICHI NE555-5V with timer from 1 to 10 seconds is a module for delaying power supply to any load.
The device is built on the basis of the universal NE555 timer, thanks to this it is possible to adjust the delay time using a trimmer resistor. Devices are controlled by means of a power relay having changeover contacts.
Relay operating principle: when power is supplied to the time delay relay, the contacts open and close after 0-10 seconds (there are normally closed and normally open contacts), and remain in this state until power is removed. For convenience, the board has an LED that lights up when power is applied.
Pinout:
"Ground" (GND) - power minus.
"Trigger" - a pulse is applied to the contact, starting the timer. Initiated by pressing the toggle switch.
"Output" - while the timer is active, an output signal is generated at the contact. Its voltage equal to V supply - 1.7V, through the limiting resistor R3 allows opening the base of transistor VT1. In turn, the semiconductor amplifier begins to pass voltage to the starting relay K1, which already switches current to the consumer. Diode VD1 in the circuit prevents a surge of parasitic currents at the moments of activation.
"Reset" (RESET) - when a negative signal is applied, the timer is set to 0 and stops. To prevent this, the circuit provides a connection of the positive power supply pole through a resistance to this contact.
"Control" (Control Voltage) - for such a simple device, this IC input is connected to ground through a capacitor. This design increases the noise immunity of the entire assembly.
"Threshold" - in the circuit, the contact is connected to the positive power supply pole. In more complex systems, its short-term shorting to minus will stop the timer.
"Discharge" - the contact is intended for connecting the 555 IC to the timing capacitor.
"Power" (VCC) - plus of the circuit voltage.

Documents and media

Product photo
Photo 1

Product inquiry

Technical questions, analog selection, samples and documentation. Reply will be sent to the email specified in the form.

NE555-5

Item code 126577 · Miscellaneous

— required fields