Skip to content

Your choice is stored for a year. You can change it at any time — the "Cookie settings" link is at the bottom of every page.

Learn more in the cookie policy.

RUICHI — home
Catalog
Contact us
PS5 — photo 1
  • Photo 1
  • Photo 2
  • Photo 3

PS5

Analog Joystick PS5 for 3D sticks

Product overview
Item code121624
ModelPS5

Specifications

ParameterValueSelect
CategorySwitches › Joysticks
Height, mm19.7 mm
Length, mm25.45 mm
MaterialPlastic / metal
ColorOrange
Width, mm20.45 mm
Select parameters to find similar products

Description

The analog PS5 joystick for 3D sticks is made of high-quality materials, thanks to which it will last a long time. After replacing the mechanisms, using the main device will be more comfortable.

1. To replace the joystick, you will need a Phillips screwdriver; you must unscrew 4 screws from the back of the gamepad housing.
2. Starting from the left part of the device:
press the housing flaps to create an opening. Carefully insert a makeshift tool, such as a flathead screwdriver, into the opening in the gap that appears and gently run it upward toward the stick; Press on the tool to open the plastic housing wider. Repeat the same steps with the right part.
3. Carefully insert two screwdrivers into the gaps that have formed and press on them near the buttons on the housing: SHARE and OPTIONS. Separate the plastic parts of the housing to the sides, but act carefully: they are still connected by ribbon cables on the boards. We recommend performing disassembly on a flat surface so that if parts fall out, they are not lost.
4. Unscrew the single bolt under the battery holder using a screwdriver. Be careful not to strip the threads.
5. Carefully disconnect the touchpad ribbon cable from the motherboard. Use special tweezers. The ribbon cable is connected to the motherboard by a special connector that can be tightened or loosened. During reassembly, to connect it back, the plastic flap must be removed from the board and the lock on the connector loosened.
6. Carefully disconnect the motherboard from the front part of the housing. The vibration motors are attached to the motherboard. Support both edges to make it easier to separate the motherboard.
7. Insert a screwdriver between the potentiometer (resistor) and the metal housing, and move it aside.
8.1. Without a soldering iron. Remove the contact pad, bring the "whiskers" together - it is released. Replace with a new one.
8.2. With a soldering iron. Desolder the mechanism completely and install a new one.
Reassemble the gamepad in reverse order

Documents and media

Product photo
Photo 1Photo 2Photo 3

Product inquiry

Technical questions, analog selection, samples and documentation. Reply will be sent to the email specified in the form.

PS5

Item code 121624 · Joysticks

— required fields